2.4g Suppliers – MoreLink MK503P 5G CPE Product Specification – MoreLink

1. Overview

Suzhou MoreLink MK503P is a 5G Sub-6 GHz CPE（Consumer Premise Equipment）device。MK503P accord with 3GPP Release 15 Communication Standard, Support 5G NSA（Non-Standalone）and SA （Standalone）。

2. Features

-      Design for IoT/M2M application

-      Support 5G and 4G LTE-A Applicable Network

-      Support 5G NSA and SA Network Mode

-      Support 5G network slicing to meet the application needs of differentiated industries

-      GNSS inside

-      Standard POE isolated power supply，802.11 af/at

-      IP67 Protection Level

-      Shell intensification，thermostability，strong

-      6KV Surge Protection，15KV ESD Protection

-      nano SIM card inside，output interface only RJ45*1

3. Applications

• Emergency broadcast

•  Security monitoring

•  Self-service vending machine

•  Billboard

•  Water conservancy and power grid

•  Patrol robot

•  Smart city

4. Technical Parameter

5. Installation Instructions

• Ethernet Cable Installation Instructions

Based on the outdoor waterproof requirements, the selection and installation of MK503P Ethernet cable need special treatment.

Ethernet cable choose：

1.The ethernet cable must be CAT5E，wire above 0.48mm
2.RJ45 Plug Must be without sheath
3.The ethernet cable must be round with a diameter greater than 5mm

Ethernet cable install：

1.Thread ethernet cable

2.Tighten waterproof cap

3.Connect ethernet cable to MK503P

4.Tighten water head

•  POE power supply Instructions

MK503P only support POE power supply，If RJ45 of application terminal support POE power supply，Application terminal can connect to MK503P through ethernet cable.

If application terminal do not support POE PSE，A gigabit POE power adapter is need. Refer to following figure for wiring.

The following figure is the wiring diagram for simulating the actual use

•  Installation

Clip installation, it is fixed on the holding pole with U-shaped clamp code.

Nut installation，fixed on other installation platforms.