China Wholesale Du 5g Coverage – MoreLink MK503SPT 5G Signal Probe Terminal Product Specification – MoreLink

Overview

MoreLink MK503SPTT (Signal Probe Terminal) is a powerful cellular frequency measure and monitor device, which polls the cellular signal that the customer SIM can use, and reports the data to PDCS through the cellular signal.

When the signal strength is below a certain threshold, the PDCS can send email notification.

PDCS

This is a cloud system. Receive all cellular signal data reported by SPT. And automatically push the information defined by the user to the designated mailbox.

Features

- 5G SPT Designed for Cellular RF monitor application

- RF Signal Threshold can be set by PDCS

- Support 5G and 4G LTE-A, 3G Applicable Network

- Support 5G NSA and SA Network Mode

- GNSS inside

- Standard POE isolated power supply，802.11 af/at

- Outdoor Design, IP67 Protection Level

- 6KV Surge Protection，15KV ESD Protection，high reliability

- Hidden nano SIM card and signal indicator design, easy to debug and install

- Powerful PDCS, easy to use

Technical Parameter

Installation Instructions

l Ethernet Cable Installation Instructions

Based on the outdoor waterproof requirements, the selection and installation of MK503SPT Ethernet cable need special treatment.

Ethernet cable choose：
1.The ethernet cable must be CAT5E，wire above 0.48mm
2.RJ45 Plug Must be without sheath
3.The ethernet cable must be round with a diameter greater than 5mm

Ethernet cable install：
1.Thread ethernet cable

2.Tighten waterproof cap

3.Connect ethernet cable to MK503P

4.Tighten water head

l POE power supply Instructions

MK503SPT support POE power supply，If RJ45 of application terminal support POE power supply，Application terminal can connect to MK503SPT through ethernet cable.

If application terminal does not support POE PSE，A gigabit POE power adapter is need. Refer to following figure for wiring.

The following figure is the wiring diagram for simulating the actual use

L Type Fixture and U Type Clip Code