ECMM, Wireless Gateway, DOCSIS 3.0, 3xFE, SMB Loop Through, HS132E

ECMM, Wireless Gateway, DOCSIS 3.0, 3xFE, SMB Loop Through, HS132E

Short Description:

The MoreLink’s HS132E is a DOCSIS 3.0 ECMM Module (Embedded Cable Modem Module) supporting up to 8 downstream and 4 upstream bonded channels to deliver a powerful high-speed Internet experience. The integrated IEEE802.11n 2×2 Wi-Fi access point significantly improves customer experience extending range and coverage with high speed.


Product Detail

Product Tags

Product Detail

The MoreLink’s HS132E is a DOCSIS 3.0 ECMM Module (Embedded Cable Modem Module) supporting up to 8 downstream and 4 upstream bonded channels to deliver a powerful high-speed Internet experience. The integrated IEEE802.11n 2×2 Wi-Fi access point significantly improves customer experience extending range and coverage with high speed.

The HS132E provides you advanced multimedia services with data rates up to 400 Mbps download and 108 Mbps upload depending on your Cable Internet provider service. That makes Internet applications far more realistic, faster, and efficient than ever before.

Product Features

➢ DOCSIS / EuroDOCSIS 3.0 compliant

➢ 8 downstream x 4 upstream bonded channels

➢ Support Full Band Capture

➢ One 10/100 Mbps Ethernet for RJ45

➢ Two 10/100 Mbps Ethernet Signals for STB

➢ RF Loop Through to STB by SMB

➢ Software upgrade by HFC network

➢ Support SNMP V1/V2/V3

➢ Support baseline privacy encryption (BPI/BPI+)

Application

➢ DVB-C or Hybrid STB embedded CM

Technical Parameters

Protocol Support

DOCSIS/EuroDOCSIS 1.1/2.0/3.0
SNMP V1/2/3
TR069

Connectivity

RF 75 OHM Female F Connector; One Loop Through by use of SMB connector
RJ45 One 10/100Mbps Base-TX Ethernet port (RJ45) with LEDs
Signal Interface 1 2.0mm 2x18 Pin Header; The signals including: Two 10/100Mbps Ethernet, USB, +12V and GND. Pin Definitions see Table-#1
Signal Interface 2 LEDs Signal to Front Panel

RF Downstream

Frequency (Edge to Edge) 88~1002 MHz (DOCSIS)
108~1002MHz (EuroDOCSIS)
Channel Bandwidth 6MHz (DOCSIS)
8MHz (EuroDOCSIS)
6/8MHz (Auto Detection, Hybrid Mode)
Modulation 64QAM, 256QAM
PHY Rate Up to 400Mbps
Signal Level Docsis: -15 to +15dBmV
Euro Docsis: -17 to +13dBmV (64QAM); -13 to +17dBmV (256QAM)

RF Upstream 

Frequency Range (Edge to Edge) 5~42MHz (DOCSIS)
5~65MHz (EuroDOCSIS)
5~85MHz (Optional)
Modulation TDMA: QPSK,8QAM,16QAM,32QAM,64QAM
S-CDMA: QPSK,8QAM,16QAM,32QAM,64QAM,128QAM
PHY Rate Up to 108Mbps by 4 Channel Bonding
RF Output Level TDMA (32/64 QAM): +17 ~ +57dBmV
TDMA (8/16 QAM):  +17 ~ +58dBmV
TDMA (QPSK):      +17 ~ +61dBmV
S-CDMA:           +17 ~ +56dBmV

RF Loop Through (SMB)

Frequency (Edge to Edge) 88 ~ 1002 MHz
Loop Through Gain >6 dB

WiFi (2.4G 2x2 11n)

Standard IEEE 802.11n
Chipset MT7628NN
MEMORY 64MB SDRAM
Flash 16MB SPI Flash
PHY Rate Max 300Mbps
Modulation Method BPSK / QPSK / 16-QAM / 64-QAM
Frequency Band 2.4 ~ 2.4835 GHz ISM Band
Spread Spectrum IEEE 802.11b: DSSS (Direct Sequence Spread Spectrum)
IEEE 802.11g/n: OFDM (Orthogonal Frequency Division Multiplexing)
RF Output Power ANT0/1: 2.4GHz >= 15dBm@11n; >= 16dBm@11g; < 20dBm@11b
AP / STA Firmware Linux 2.6.36 SDK
Operation Mode Green AP/STA
Receiver Sensitivity ANT0/1: 11Mbps -86dBm@8%; 54Mbps -73dBm@10%; 130Mbps -69dBm@10%
Security WEP,WPA, WPA2
Antenna 2xIpex connector

Networking

Network protocol IP/TCP/UDP/ARP/ICMP/DHCP/TFTP/SNMP/HTTP/TR069/VPN (L2 and L3)
Routing DNS / DHCP server / RIP I and II
Internet Sharing NAT / NAPT / DHCP server / DNS
SNMP version SNMP v1/v2/v3
DHCP server Built-in DHCP server to distribute IP address to CPE by CM’s Ethernet port
DCHP client CM automatically gets IP and DNS server address from MSO DHCP server

Mechanical

Dimensions (TBD) 133mm x 99mm x 20mm (Including Heatsink)
WPS Button WPS Button

Environmental

Power Input 12V/1A
Power Consumption 12W (Max.)
Operating Temperature 0 to 40 oC
Operating Humidity 10~90% (Non Condensing)
Storage Temperature -40 to 85 oC

Interface Pin Definition and Mechanical Characteristic

F Connector:

1 (1)

RF Loop Throughput: SMB, 75 OHM, Straight Angle, DIP

1 (7)

RJ45, w/Shielding, w/LED, w/o Transformer, Yellow, Right Angle, DIP

1 (5)

Signal Interface 1: Pin Header, 2x18, 2.0mm, K31, K32, Straight Angle, SMD

Table #1: Signal Interface 1

Pin1

RX1+

Pin19

GROUND

Pin2

RX1-

Pin20

USB_DP

Pin3

TX1+

Pin21

NC

Pin4

TX1-

Pin22

NC

Pin5

RX2+

Pin23

NC

Pin6

RX2-

Pin24

NC

Pin7

TX2+

Pin25

NC

Pin8

TX2-

Pin26

NC

Pin9

NC

Pin27

NC

Pin10

NC

Pin28

NC

Pin11

NC

Pin29

NC

Pin12

NC

Pin30

NC

Pin13

NC

Pin31

K

Pin14

GROUND

Pin32

K

Pin15

GROUND

Pin33

+12V

Pin16

USB_DM

Pin34

+12V

Pin17

GROUND

Pin35

GND

Pin18

USB_DM

Pin36

GND

Note: NC-No Connect; K-No Pin

1 (6)

Signal Interface 2: Wafer Header, 1x6, 2.54mm, w/Latch, Straight Angle, DIP

Table #2: Signal Interface 2

Pin1

GROUND

Pin2

WIFI_LED_N

Pin3

DOCSIS_DS_LED_N

Pin4

DOCSIS_US_LED_N

Pin5

DOCSIS_ONLINE_LED_N

Pin6

CM_ACTIVITY_LED_N

1 (8)

Reset Button: TACT Switch, 4P, Right Angle, DIP

Press and hold this Reset Button for about 1 ~ 3 seconds, this will enable WiFi WPS function.

Press and hold this Reset Button for at least 10 seconds, then Reset WiFi to Factory Default Settings.

1 (9)

PCBA, Mechanical Characteristic 

1 (11)

TOP

1 (10)

BOTTOM


  • Previous:
  • Next:

  • Related Products